Drawings
SV-15B
- This was a quite complex drawing. the array of circles in the middle was hard to get perfect, but was not impossible. The rounded edge on the bottom right was done by using tangent, tangent, radius. One of my favorite drawings. Grade: 100.
|
SV-5,6
- The bulk of these two designs used tangent, tangent, radius. That is one of my favorite commands and i liked this drawing a lot. I needed to decrease my decimals in my dimensions. Grade: 90.
|
SV-6B
- This drawing was easy, besides for getting the 40 degree angle. Tan tan radius was used and decimals need to be decreased. Grade: 100.
|
SV-7B
- This was a fun drawing. Took a little while to build the chair, but took even longer to rotate the two chairs along the midpoint on the one chair. I had to draw a lot of circles around a center point, and do a lot of trimming, but I liked to figure it out! Grade: 100. |
SV-8
- This drawing was super easy. You only had to draw one side and the rotate it 180 degrees along the midpoint. This is one of the first drawings that used fractions for dimensions. I liked this single view a lot. Grade: 100. |